Rear Bumper Removal

Here you will found out how to remove the rear bumper from the Evo 4, 5 or 6.  This is a fairly easy procedure as you will see.

I have omitted the removal of the splash guards just behind each rear wheel, so you will remove those first. You will also have to remove the boot lining to access the fixing screws for the bumper.

Click on the image to see the bigger picture.

Remove the hidden screw at each side as shown in the picture opposite.

On the left hand side you will see the screen wash reservoir. remove the fixing screw and tilt the reservoir up out of the way. Behind it you will find the side fixing for the rear bumper.

The right had side fixing is dead opposite beneath the AYC reservoir.

You will find under each rear light housing a stud protruding through with a nut on - the nut needs removing.

This then leaves the two main fixings circled left. Once you have removed these the bumper can be removed from the vehicle. Depending on where your fog light is mounted you may have a wire to disconnect. I would advise using liberal amounts of copper slip upon re-assembly to help prevent the various screws and bolts from becoming seized over time.

---